What the heck did he just say?????

the first was started but I had to put a little 'hand near the air flow is now trying to start it but the engine will not start and smells like gas can be a sensor?

|UPDATED|8/21/2012 2:26:20 AM (AZT)|/UPDATED|

fabio075  is from Italy, so ya'll give the feller a break on his English typing! 
fabio, from what I can understand, it sounds like you may have a large vacuum leak somewhere that is keeping the engine from starting now. Putting your hand over the MAF sensor would help, and that's why it tries to run like that. Look for a vacuum hose that is broken, damaged, or loose somewhere on the engine.


______________

Joel Adams  
My Link

    
(click for Texas-sized view!)             NCRS

"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"

I'm Italian you guessed

The oil pressure switch sends a redundant signal to the fuel pump relay. It should not cause a "no start", unless there is a problem with the "normal" relay signal from the ECM. A lot of times, if there is a problem with the "normal" signal for the relay, you have to crank on the engine for a while to get oil pressure before it will start.
You said you smelled fuel, so it sounds like the fuel pump is working.
Do you have any way to get the trouble codes, and see if it is setting any codes?


______________

Joel Adams  
My Link

    
(click for Texas-sized view!)             NCRS

"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"

Did the "no start" occur on it's own ?? Or did you replace the distributor and then it wouldn't start? In a previous post you mention "gears".....did you also replace the timing chain and gears? I'm trying to figure out when the no start occured....before or after some type of engine work.

I also replace the gear on the distributor, but seems to have
 adams  The ALDL cavo.com, program know which is better?

i, would like to help however i'm staying out of this one.  sounds like he put the dist in 180 out.  if i understood it corectly

______________

 

trying to move forward, but will not start I can not understand I've seen all the cables and all cables are affixed

Here's a video about how to get #1 Top Dead Center...install the distributor....direction of rotor rotation and firing order. It's not in Italian ---but hopefully if your problem is with the distributor install and ignition timing this may help.

thanks for the video is very interesting
       I tried and tried and phase, but does not want to start