Ok so here's the deal. I have the 14101128 the stock heads that came with my 87. I had an overheating issue with exhaust also pressuring the cooling system. I removed one head so far and noticed a small crack in the bolt hole.
I also have a set of 14102187cast iron heads that will swap over according to a visual inspection.
So the questions are cracked aluminum head.
1. What would the cost be to have a machine shop repair it?
2. Has anyone ever used these 14102187 heads? If so what's your thoughts?
Corvette is a registered trademark of the General Motors Corporation(GM) &
Chevrolet Motor Division. Vette Registries, LLC is responsible for all site content (except for member submitted content or where otherwise
noted) and does not claim or imply that Chevrolet or
GM is responsible for Official C4 Vette Registry content. Vette Registries, LLC is independent from GM and is not affiliated
with, sponsored or supported by GM. Copyright/trademark/sales mark
infringements are not intended, or implied and are in fact used to support
GM, Chevrolet and Corvette.
Official C4 Vette Registry content is Copyright 2001-2018, Vette Registries, LLC. Content may not be reused without written consent. All Rights Reserved. NS
Corvette (Vette) Model Years on this site: 1984 1985 1986 1987 1988 1989 1990 1991 1992 1993 1994 1995 1996