This is first post but glad to be in the club. I have a 1986 corvette that I am putting a 2004 tahoe 5.3l vortec in. Stock 700r4 trany. I know I need the spacer for the flex plate,I am getting motor mounts made by a friend. But I have alot of questions never done this before. I am a diesel tech and have worked on about everything but not a swap like this. I just want to keep everything stock that I can. First thing is does anyone know what intake will work on a 5.3 that is low profile and will reuse injector and truck harness. Then the other issue is of course oil pan is too deep what do I need there any help would be great.
Corvette is a registered trademark of the General Motors Corporation(GM) &
Chevrolet Motor Division. Vette Registries, LLC is responsible for all site content (except for member submitted content or where otherwise
noted) and does not claim or imply that Chevrolet or
GM is responsible for Official C4 Vette Registry content. Vette Registries, LLC is independent from GM and is not affiliated
with, sponsored or supported by GM. Copyright/trademark/sales mark
infringements are not intended, or implied and are in fact used to support
GM, Chevrolet and Corvette.
Official C4 Vette Registry content is Copyright 2001-2017, Vette Registries, LLC. Content may not be reused without written consent. All Rights Reserved. NS
Corvette (Vette) Model Years on this site: 1984 1985 1986 1987 1988 1989 1990 1991 1992 1993 1994 1995 1996