I am reassembling the rear suspension on my 1987 corvette. I am hoping someone can help me with the following torque specs
Upper control rods
Lower control rods
Carrier support arms
Spindle rods where they bolt to the knuckle
I would appreciate any help that you can offer
Thanks for the help Adam. I am going to test the theory of no "dumb" questions . I took a picture of the rear end and looked at the torque specs you sent me. I want to make sure that I am identifying the correct bolts. Can you take a look at the picture and let me know if I have it right? Much Appreciated!
Corvette is a registered trademark of the General Motors Corporation(GM) &
Chevrolet Motor Division. Vette Registries, LLC is responsible for all site content (except for member submitted content or where otherwise
noted) and does not claim or imply that Chevrolet or
GM is responsible for Official C4 Vette Registry content. Vette Registries, LLC is independent from GM and is not affiliated
with, sponsored or supported by GM. Copyright/trademark/sales mark
infringements are not intended, or implied and are in fact used to support
GM, Chevrolet and Corvette.
Official C4 Vette Registry content is Copyright 2001-2018, Vette Registries, LLC. Content may not be reused without written consent. All Rights Reserved. NS
Corvette (Vette) Model Years on this site: 1984 1985 1986 1987 1988 1989 1990 1991 1992 1993 1994 1995 1996