Topic: Manifold Air Temperature (MAT) Sensor
in Forum: C4 Electrical
Already a Member?
Click Here to Login
Not yet a Member?
Click Here to Register for Free!
SPONSOR AD:: (Our Sponsors help support C4VR)
Standard Member
Send PM
San Jose, CA - USA
Joined: 5/10/2012
Posts: 81
Vette(s): 1988 Corvette / Blue Pearl
I just relocated mine a few weeks ago , Removing the top plenum is not needed. I found it easier disconnect it from the Passenger side , It's right in line with Cylinder #6 . I used a large flat head screw driver & Needle nose pliers. I would just advise you to make sure you're ready to relocate it ....Because it's a pain in the Arse to get back on ,unless you have really small hands. good Luck .
Standard Member
Send PM
San Jose, CA - USA
Joined: 5/10/2012
Posts: 81
Vette(s): 1988 Corvette / Blue Pearl
No worries , Hope all goes well ...... you will notice a difference.
Relocated mine also. Makes a difference because you are now measuring cold fresh air instead of hot air in the stock position. Here is a link on Ebay for your '89 http://www.ebay.com/sch/i.html?_odkw=1988+corvette+9th+injector+delete+kit&_osacat=0&_from=R40&_trksid=p2045573.m570.l1313.TR0.TRC0.H0.X1989+corvette+mat+sensor+relocating+kit&_nkw=1989+corvette+mat+sensor+relocating+kit&_sacat=0
in Forum: C4 Electrical
SPONSOR AD: (Our Sponsors help support C4VR)