Topic: Removing Sport Seats Back Cushions
in Forum: C4 Interior
Already a Member?
Click Here to Login
Not yet a Member?
Click Here to Register for Free!
I own a 1988 35th anniversary edition with sport seats and 3,800 miles on the odometer. The car is like new. I repaired the lumbar support pumps and now want to change out the lumbar support bladders. Can someone instruct me on how to remove the seat back cushions without damaging them and get them back on the car correctly? The seats are in perfect condition and I am reluctant to mess them up. Can't find any local trim shop to contract with.
Marshall
SPONSOR AD:: (Our Sponsors help support C4VR)
Standard Member
Moderator
Send PM
Moderator
lanoka harbor, NJ - USA
Joined: 3/22/2009
Posts: 1363
Vette(s): 1990 L-98 white/ red/black leather interior targa top auto
1975 L48 blue/black leather interior t tops auto
on my seats all i have to do is push sideways on the cushion right below the headrest and the cushion pops off. there is a clip on each side that holds the cushion on. hope this helps
the dynamic duo
c3vr life member #97
Thanks for the quick response.
Did you release the clip by reaching in between the side bolster and center cushion to get to the clip?
Did you need to separate the above pieces by removing hog rings?
What type of device did you use to push on the clip?
How did you avoid damaging the seats?
Was it difficult getting the cushions back into the clips?
These are my worries.
MJG
Standard Member
Moderator
Send PM
Moderator
lanoka harbor, NJ - USA
Joined: 3/22/2009
Posts: 1363
Vette(s): 1990 L-98 white/ red/black leather interior targa top auto
1975 L48 blue/black leather interior t tops auto
the clip is attached to the seat back. should only have to push on the side of the cushion until one side releases and the whole cushion comes off. you can then lift the bottom cushion and unclip it and take it out too.
the dynamic duo
c3vr life member #97
in Forum: C4 Interior
SPONSOR AD: (Our Sponsors help support C4VR)